Is this PCB layer stackup OK? Solid GND – Signal Layer – Split Planes
Watch what happens when PCB tracks are routed over split planes. Thank you very much Yuriy Shlepnev
Chapters:
- 00:00What is this video about
- 00:58Setup
- 04:55Example: Symmetrical - Solid ground planes on the top and bottom
- 11:14Example: Symmetrical with a split on top plane
- 16:03Example: Not-symmetrical - Solid ground planes on the top and bottom
- 20:29Example: Not-symmetrical with a split plane far
- 23:53Example: Gap with a bridge
- 27:13Example: Partial cutout
- 35:52Example: Crosstalk when routing over gap on far plane
- 38:22Example: Crosstalk when routing over gap in near plane
- 40:15Example: Crosstalk when routing differential pair over gap
- 49:33AI in signal simulation software
