USE DISCOUNT CODE
EXPERT30
TO SAVE $30 USD
Altium PCB Origin
Nigel Bishop , 05-18-2020, 03:15 AM
How do you change the Origin to a drilled hole, I never normally use a board edge
robertferanec , 05-18-2020, 08:20 AM
it is in drill config (in your job file, right click in Fabrication outputs -> NC Drill Files -> Configure ):
Nigel Bishop , 05-19-2020, 04:35 AM
Hi Robert, this is not quite what I meant, in your video, where you set origin to bottom left corner of board (Edit>Origin>Set) can you select a pin or pad at this point
robertferanec , 05-19-2020, 05:19 AM
yes, you can set origin anywhere.
Use our interactive Discord forum to reply or ask new questions.