USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
custom pad and high voltage gap
cometa , 03-29-2018, 05:39 AM
Hello
I must to create a custom pad like in photo 1 and also a high voltage gap photo 2
can somebody explain to me how i do this?
Photo 1 for pad
Photo 2 for gap
I must to create a custom pad like in photo 1 and also a high voltage gap photo 2
can somebody explain to me how i do this?
Photo 1 for pad
Photo 2 for gap
alferdvidal , 03-29-2018, 01:46 PM
Hi cometa
If you want to create a pad in image 1, you need to have a padding dashboard and create it in the Altium library.
If you explain more, I might be able to help
Regards
Alfred
If you want to create a pad in image 1, you need to have a padding dashboard and create it in the Altium library.
If you explain more, I might be able to help
Regards
Alfred
cometa , 03-30-2018, 02:51 AM
Hello,
My pad from pic1 i want to have 3X4mm,
I attached picture, but also please tell me how can i create this,
Thx
My pad from pic1 i want to have 3X4mm,
I attached picture, but also please tell me how can i create this,
Thx
alferdvidal , 03-30-2018, 01:18 PM
Hi cometa
You can create a fill of 3 × 4 on the board and put three pads on it and give it the desired net.
In Figure 2 you have an electric discharger that I do not know
I hope that I will help you
good luck
alferd
You can create a fill of 3 × 4 on the board and put three pads on it and give it the desired net.
In Figure 2 you have an electric discharger that I do not know
I hope that I will help you
good luck
alferd
cometa , 04-02-2018, 12:36 AM
Thank you Alferd !
alferdvidal , 04-02-2018, 01:26 AM
you welcom
robertferanec , 04-02-2018, 02:53 PM
@cometa, as @alferdvidal sugegsted, you can create schematic symbol with three pins, place it into schematic where it should be connected and create footprint for that symbol. Some time ago I created a video how to create symbols and footprints, this may help you: https://youtu.be/65hJw_dM5Jk
The second footprint - you could create it for example as a 2 pin component. So create a 2 pin symbol and assign special 2 pin footprint to it. The question is how to create the zig zag there - maybe create custom pads: https://www.altium.com/documentation...ad+Shapes))_AD
The second footprint - you could create it for example as a 2 pin component. So create a 2 pin symbol and assign special 2 pin footprint to it. The question is how to create the zig zag there - maybe create custom pads: https://www.altium.com/documentation...ad+Shapes))_AD
alferdvidal , 04-02-2018, 03:03 PM
Thank you so much Robert
Use our interactive Discord forum to reply or ask new questions.