USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
[ALTIUM 18] issue with variants and pdf output
Modjo , 11-29-2018, 01:26 PM
Hi, on a personal card project, i have created a variant for my card. this work fine on schematic but when i want to make a pdf of all the schematic in my recent variant it didn't work. There is always create in no variant mode ... The step that i followed is
- create the variant
- compile the project
- select the variant created in Variants tree
- define the component not fitted
- compile the projet
- in the output job select the variant just created
But this don't work. For the schematic print, i can't select the variant. See picture under
- create the variant
- compile the project
- select the variant created in Variants tree
- define the component not fitted
- compile the projet
- in the output job select the variant just created
But this don't work. For the schematic print, i can't select the variant. See picture under
robertferanec , 12-02-2018, 11:15 AM
Hmm, I tried that on my finished 28 pins project and I can see all the variants in the list. Try to select [PCB Document] in the filed two columns on the left (I can not take screenshot at this moment, but if it doesn't work for you, let me know, once I am in the office I will take the screenshot)
Modjo , 12-02-2018, 01:44 PM
Hi, yes i have just tested before your message and it's working. That's strange to need to specify this option to activate variants !
Use our interactive Discord forum to reply or ask new questions.