USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
Difficulties in Altium Routing
tariq1996 , 05-31-2023, 06:18 AM
Hi,
Suddenly, after I create my board, there was an area that I can not access, route,e or even do anything with it, it seems like there is a room for the board or something and I didn't update it, I don't know.
Does anyone face the same problem?
Thank you..
(hence: I can not connect anything to the pad (11), plz see below)
Suddenly, after I create my board, there was an area that I can not access, route,e or even do anything with it, it seems like there is a room for the board or something and I didn't update it, I don't know.
Does anyone face the same problem?
Thank you..
(hence: I can not connect anything to the pad (11), plz see below)
qdrives , 05-31-2023, 05:11 PM
What if you do Design / Net list / Clean all nets
or Design / Net list / clear all nets
And update from the schematic to the board again?
or Design / Net list / clear all nets
And update from the schematic to the board again?
Use our interactive Discord forum to reply or ask new questions.