This website uses cookies
We use cookies or simmilar technologies to ensure you get the best experience on our website. By continuing to browse this website you consent to the use of such technologies. For more information visit our Privacy Policy.
| FORUM

FEDEVEL
Platform forum

USE DISCOUNT CODE
EXPERT30
TO SAVE $30 USD

From-To Editor in AD17 cannot calculate length

milos.stankovic , 02-17-2019, 03:34 AM
Hi!
I am doing Lesson4 in Advanced PCB Layout Course. I am trying to use From-To Editor to calculate length for DRAM_A5 signal as Robert presented in his video. I Added 4 pin pairs in From-To Editor, then I added Class DRAM_ADDR, then I added DRAM_ADDR rule in Design Rules->High Speed->Matched Net Lengths. I run DRC and it reports that nets are not connected at all.
Any suggestion what I am doing wrong?

Best regards,
Milos
robertferanec , 02-18-2019, 02:51 AM
Interesting. The first picture shows zeros in the bottom table ... interesting. It really looks like it is not fully routed?! Did you figure it out?
Comments:
milos.stankovic, 02-18-2019, 02:59 AM
No, not yet. I will try if it works in AD18.
robertferanec , 02-18-2019, 03:18 AM
In AD18, you can use xSignals, it is much better: https://www.youtube.com/watch?v=jpk-hfsFaqA
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?