USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
ground node no found
Juliacx , 11-11-2022, 06:53 AM
I have error like this but i have a GND in my schematic
qdrives , 11-11-2022, 02:27 PM
In simulation or schematic (validation)?
For simulation I guess you would need a special Gnd connection (at least that is in LTSpice).
It also mentions it here: https://www.altium.com/documentation...mulation-guide
However, it does not mention how to do it...
How do you have Gnd? Netlabel, port(s) or power port?
For simulation I guess you would need a special Gnd connection (at least that is in LTSpice).
It also mentions it here: https://www.altium.com/documentation...mulation-guide
However, it does not mention how to do it...
How do you have Gnd? Netlabel, port(s) or power port?
Juliacx , 11-11-2022, 04:51 PM
In simulation in validation is no error
What is the difference between simulation and schematic validation?
What is the difference between simulation and schematic validation?
robertferanec , 11-12-2022, 03:26 AM
I have never seen an error like this. What do you run to get this error (where do you click)?
qdrives , 11-12-2022, 09:13 AM
Simulation need a Gnd. That is the 'zero' volt net.
Problem is, I cannot find how to place it.
However, if I check simulate on my schematic, about the only issues I get are missing and some wrong models.
What if you place a Gnd power port to one of your Gnd nets?
Problem is, I cannot find how to place it.
However, if I check simulate on my schematic, about the only issues I get are missing and some wrong models.
What if you place a Gnd power port to one of your Gnd nets?
Juliacx , 11-12-2022, 11:19 AM
nope, still the same
qdrives , 11-13-2022, 08:12 AM
Do you have a voltage source?
Like VSRC or Battery?
Like VSRC or Battery?
Use our interactive Discord forum to reply or ask new questions.