This website uses cookies
We use cookies or simmilar technologies to ensure you get the best experience on our website. By continuing to browse this website you consent to the use of such technologies. For more information visit our Privacy Policy.
| FORUM

FEDEVEL
Platform forum

USE DISCOUNT CODE
EXPERT30
TO SAVE $30 USD

Ground polygon removed at the edges

nikhil2402 , 10-08-2018, 04:03 PM
Hello Everyone,

I have been facing the following problem:

When I pour a ground polygon and have cutouts around certain pads, the ground misses to fill at the corners of the cutouts as shown in picture below.

I had this problem sometime before as well but I solved it with some trial and error. But this time I am not able to get rid of this.

Does any one have a solution for this?

Thanks
Paul van Avesaath , 10-09-2018, 03:55 AM
I have the same issue once i a while, no solution found.. can live with it in most cases.. it is a rule thing or at least thats my guess... havent checked the altium forums for this particular thing..
mohsin_qau , 10-09-2018, 07:26 AM
Please review the Polygon-Pad Clearances and Polygon Dead Copper Region.
robertferanec , 10-10-2018, 02:52 AM
as @mohsin_qau is suggesting, have a look at polygon properties and rules. You may want to try to use smaller numbers there:



Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?