USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
Coaxial Connector for custom MCU board
rafuchosnow , 10-20-2024, 11:20 PM
Hey fellas. I'm replicating a PCB for a sensor that is used in my project and I'm not familiar with the schematic of Coaxial Connectors. If I'm not mistaken, 1 goes to data, and 2-4 go to GND?
rafuchosnow , 10-20-2024, 11:27 PM
Robert Feranec , 10-21-2024, 04:23 AM
compare pin numbers of the schematic symbol with pin numbers in footprint - that way you will see where exactly on the physical connector these pins are located.
QDrives , 10-21-2024, 08:45 PM
The connector probably has 3 Gnd pins. The schematic symbol shows all these pin individually.This is part design (visualization) choice and could part be a limit in the EDA tool.
rafuchosnow , 10-21-2024, 09:58 PM
Well, this is the schematic of the board I'm trying to replicate for my project. It's by DFRobot and it's for a pH Sensor
Use our interactive Discord forum to reply or ask new questions.