Opamp output at VCC OFF condition
jebin , 10-04-2018, 07:36 AM
Hi,
My requirement is in power off condition i should not feed input voltage to the Processor IO,s (IO i used Level translator)and ADC channels. To do that what i did is i have used LM324LV Op-amp in voltage flower configuration and Opamp VCC will be controlled by Processor.
Conditions:-
i am feeding voltage input to op-amp Non-inverting Pin (+) and op-amp VCC is OFF.
example : Non-inverting pin input voltage - 0.8V and VCC 0V (OFF) and op-amp configured as a Voltage follower.
Question:
In this condition what would be op-amp output will be 0V? or 0.8V? or ...?.
Jebin
My requirement is in power off condition i should not feed input voltage to the Processor IO,s (IO i used Level translator)and ADC channels. To do that what i did is i have used LM324LV Op-amp in voltage flower configuration and Opamp VCC will be controlled by Processor.
Conditions:-
i am feeding voltage input to op-amp Non-inverting Pin (+) and op-amp VCC is OFF.
example : Non-inverting pin input voltage - 0.8V and VCC 0V (OFF) and op-amp configured as a Voltage follower.
Question:
In this condition what would be op-amp output will be 0V? or 0.8V? or ...?.
Jebin
mohsin_qau , 10-04-2018, 08:34 AM
Can you please send the Schematics for better understanding
robertferanec , 10-08-2018, 03:13 AM
This is what we used, page 24: http://www.imx6rex.com/wp-content/up...Production.pdf
PS: Maybe have a look also at analog switch chips. I have never used Opamps for this purpose, but it may depend on the rest of the circuit.
PS: Maybe have a look also at analog switch chips. I have never used Opamps for this purpose, but it may depend on the rest of the circuit.
jebin , 10-21-2018, 09:19 AM
I have used Analog switch(SN74HC4066DR) for this purpose.
Use our interactive Discord forum to reply or ask new questions.