USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
STM32 ST-LINK Utility can not connect to the card in normal mode.
sheldor , 02-06-2024, 01:17 PM
Hello all, I designed my first card with STM. I am trying to connect with ST-Link but in STM32 ST-LINK Utility I can't connect the card in normal mode. However it works in Hot Plug mode. Does anyone have any idea about it?
Mini , 02-06-2024, 02:25 PM
I have had same problem, but can't remember what i did. Why are you st-link utility? It is kinda outdated. Try STM32CubeProgrammer first. Next can you show us your programming connections on schematic? How did you connect them?
Mini , 02-06-2024, 02:26 PM
Did you connect reset signal? I usually use "connect under reset". Can you try to hold your MCU in reset state and then try to connect?
Mini , 02-06-2024, 02:27 PM
How do you power your circuit? Which programmer do you use?
Mini , 02-06-2024, 02:28 PM
Have you uploaded software already? Are you sure you are not overwriting SWD pins in your software?
Use our interactive
Discord forum to reply or ask new questions.